Car Stickers installation in 4 EASY Steps!

Car stickers.. definitely the most EASY and CHEAP car modification!

Stickers don´t turn your car faster but are a great way to personalize and make your car stand out from the crowd and guess what.. they are inexpensive and very easy to install.

 

 

General Car Stickers Installation

decals-application-instructions-2
1. CLEAN: Wipe clean the surface you are applying the decal to with a mild cleaner. Allow to dry.

2. PEEL: Carefully peel off the backing layer from the decal. (Only the decal design and the clear transfer layer should remain).

3. APPLY: Place your decal on the surface. Use the finger or a credit card to rub and smooth the decal onto it.

4. REMOVE: Now remove the clear transfer layer by peeling it off starting from the corner. (Only the decal design should remain).

Now that you learned how to install them..

want to grab some awesome stickers for your car?

Tire Stickers .. the look and feel of a race car!

So.. What is so special about the Tire Stickers?

Mainly used in race cars as branding solution, tire stickers are also becoming used more and more out of the racing circuits. This seems to be found as an great way to pop the look of every car, personalize and to give it some feel of a race car.

This stickers are made of rubber intended to adhere to the sidewall of the tire.  The results of this tire letters stickers in our opinion are awesome but in case something goes wrong with the installation or for some other reason you are able to fully remove them.

 

They look awesome but.. How easy is the tire stickers installation ?

Well.. it´s a very easy process and for sure that anyone can do it! It can been done in a couple of hours and you don´t even need to take the wheel out of your car!

 

WHAT WOULD BE NEEDED TO MAKE THE APPLICATION?
  • The tire stickers ( Find good quality permanent stickers here )
  • A shop rag
  • Fine sandpaper
  • Acetone

 

Preparation of the surface:
1 – Clean well the surface of the tire where you are going to apply the tyre stickers using acetone and a shop rag. Repeat the process for 3 or 4 times since dirt or oil residues could compromise the end result.

2 – Lightly sand the surface or area where the tyre stickers will be applied.

3 – Repeat the process 1 and this time also clean the backside of the sticker with acetone.

 

 Sticker application:
4 – Apply the rubber adhesive on the back side of sticker (the adhesive usually is supplied with the stickers).

5 – Align the sticker on the tire and then with light pressure stick it.

6 – Let it dry for at least 1 hour before you drive the car.

 

THAT´S IT!  TYRE STICKERS INSTALLED !!

 

NOW.. LETS SEE SOME EXAMPLES!